Puffco Proxy: Complete Usage & Maintenance Guide

The Puffco Proxy is a modular, portable vaporizer designed for concentrate enthusiasts seeking versatility and performance. With its innovative 3D Chamber technology and customizable accessories, it's essential to understand its operation for optimal use.

📦 What's Included

• Proxy Base Unit
• Glass Pipe Attachment
• 3D Ceramic Chamber
• Carb Cap & Tether
• USB-C Charging Cable
• Loading Tool
• Dual Tools (5)
• Carrying Case

🔋 Charging Your Proxy

1. Connect the Charger: Use the provided USB-C cable to connect the Proxy to a power source.

   Charging Indicators:

   • Pulsing Green Light: Charging in progress.

   • Light Off: Fully charged.

     Charging Duration: Approximately 1.5 hours for a full charge.

     Battery Check: Triple-click the power button:

   • Green: 100%–60%
   • Yellow: 60%–30%
   • Red: 30%–0%

Note: It's recommended to use the provided charging cable and a reliable charging brick for optimal performance .

🔥 Operating the Proxy

1. Power On/Off: Hold the power button for 3 seconds to turn the device on or off.

   Select Heat Setting: Single-click the power button to cycle through:

   • Blue: Low
   • Green: Medium
   • Red: High

   • White: Peak

     Load Concentrate:

   • Remove the carb cap.
   • Use the loading tool to place a small amount of concentrate into the chamber.
   • Replace the carb cap securely.
2. Initiate Heating: Double-click the power button. The device will pulse to indicate heating and vibrate when ready.
3. Inhale: Draw gently through the mouthpiece. For extended sessions, double-click during use to activate Boost Mode, which increases heat and extends the session duration.

Note: Avoid initiating more than four consecutive heating cycles to prevent overheating .

🌈 Light Indicators & Modes

• Heating Up: Pulsing light.

  Ready: Device vibrates and light flashes.

  Battery Level Check (Triple-click power button):

  • Green: 100%–60%
  • Yellow: 60%–30%

  • Red: 30%–0%

    Error Codes:

  • 3 White Flashes: Chamber not attached properly.
  • Solid Red Light: Device overheating.

Note: If the device shows a solid red light for 5 seconds and won't heat, allow it to cool down before retrying .

🧼 Cleaning & Maintenance

1. After Each Use:

   • While the chamber is still warm, use a cotton swab to gently clean any residue.

     Deep Cleaning (Recommended weekly):

   • Chamber:
     • Remove and soak in 90%+ isopropyl alcohol for 20–30 minutes.

     • Rinse thoroughly and let dry completely.

       Glass Attachment:

     • Soak in isopropyl alcohol.

     • Rinse thoroughly and air dry.

       Base:

     • Gently clean the gold contact points and air path using a cotton swab dipped in isopropyl alcohol.
     • Avoid flooding or soaking the base with alcohol.

Note: Ensure all components are completely dry before reassembling the device .